Operating Instructions - Kobalt KMS 0724B-03 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS

When transporting the saw, turn off the saw and remove the battery pack from the miter saw,
then lower the saw arm and lock it in the "DOWN" position. Lock the saw arm by depressing
the arm-lock pin (AC). A carrying handle (AD) is located on the top of the saw arm. Never lift
the saw by the main handle on the front end of the saw arm or by the fence.
Always maintain a speed and pressure that will allow cutting without overheating the saw
blade. Applying too much pressure will overheat the saw and melt the plastic. Do not force the
saw, let the tool do the work.
WARNING
• To reduce the risk of injury, wear safety goggles or glasses with side shields.
• Before each use, verify that the blade is free of cracks, loose teeth, missing teeth, or any
other damage. Do not use if damage is observed or suspected.
• Do not start the miter saw without checking for interference between the blade and the miter
fence. Damage could result to the blade if it strikes the miter fence during operation of the saw.
• Always wait for the blade to stop completely, and remove the battery pack from the miter
saw before changing accessories or making adjustments.
13. To Install/Remove Battery Pack
To Attach Battery Pack
a. Make sure that the On/Off switch (B) is in the
OFF position.
b. Align the raised portion on the battery pack with
the grooves on the bottom of the tool, and then
slide the battery pack onto the tool as shown.
c. Ensure that the battery-release buttons on the
battery pack snap into place and the battery
pack is secured to the tool before beginning
operation.
NOTICE: When placing the battery pack on the tool,
be sure that the raised rib on the battery pack aligns
with the groove on the tool and the latches snap into place properly. Improper assembly of the
battery pack can cause damage to internal components.
To Detach Battery Pack
a. Make sure that the On/Off switch (B) is in the OFF position.
b. Press the battery-release buttons to release the battery pack.
c. Pull backward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always remove the battery pack
from the tool when the tool is not in use or when carrying the tool.
13
19
Battery-release
button

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido