Installing The Rudder Deployment Control Line Assembly - Wilderness Systems Helix PD El Manual Del Propietario

8.6 Installing the Rudder Deployment Control Line Assembly

Items needed:
• Rudder Deployment Control Line Assembly (B6)
• Round Deck Fitting (B4)
• 10-32 x ¾" Screw (B5) Screw
• Tape Measure
Locate the final round lift line deck fitting recess molded into the right side of the Kayak behind the paddle park at the seating
well. Remove and discard the filler screw from the insert. Place the rudder deployment control line bungee (B6) into the slots
on the back of the round deck fitting (B4) and secure to the insert in the recess with 10-32 x ¾" screw (B5). See illustration for
proper configuration.
Lower the rudder (B) to the vertical deployed position by hand. Ensure the rudder is in a straight steer position. Thread the lift
lines from the rudder forward through the three round deck fitting (B4) that you have secured to the kayak. The lift line from
the left side of the rudder (B) routes through the top of the round deck fittings (B4) and the lift line from the right side of the
rudder (B) routes through the bottom of the round deck fittings (B4).
Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607 11