Getting Started - MEI CASHFLOW 7000 Serie Manual De Instrucciones

Ocultar thumbs Ver también para CASHFLOW 7000 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 32
At power up, the CF7000 will run a self test, where the CF7000 motor will sound,
the LED's will cycle five times through a sequence of red, amber & green.
On CF7900 the LCD display briefly shows its software revision and as there are
no coins in the tube cassette, the display will show a "Low Tubes" message
requesting that the coin tubes be filled to a predefined level (
). Once the CF7000 has enough coins in the tubes, the LCD display
tubes section
will show the coin totals (in currency value) stored in the tubes.
Note: MEI recommends that a small number of coins (e.g. 5 of each) be inserted
in each tube prior to leaving the machine.
Floating the Coin Tubes
There are two ways to float the CF7000 tubes with coins.
1) Manually fill each tube by inserting coins into the tubes.
2) Use the Service Mode and insert coins through the discriminator.
Filling Tubes Manually
1. Remove the tube cassette from the CF7000.
2. Insert required number of coins into relevant storage tubes.
3. Re-fit tube cassette back on to the CF7000.
The CF7000 will now begin an automatic tube calibration measurement where a
clicking sound will be heard, this is normal. On CF7900 once calibration is
complete the display will show a total currency value of the coins inserted. If a
tube is left empty the display will show a tube low message for the particular tube.
Fill Tube using Service Mode
1. Press the Yellow 'Mode' button once.
2. Press 'A' button and start inserting coins through the discriminator.
3. On CF7900 the display will show the number of coins that are required for
each tube. (the displayed count will decrement as coins are inserted)
4. Press 'A' button to exit float mode.
CF7000 Menu Structure
Setup Mode
There are two ways to access the Setup Mode menus.
1. Press and hold the 'Mode' button for 2 seconds.
2. Press the 'Mode' button once and select the 'Setup' option by pressing
button 'E'. (This method requires a pass code. When asked for this, press
buttons 'A''B''C').
www.vendival.com

GETTING STARTED

(CF7900 only)
Page 5 of 10
Tel. 902 07 07 59 - Whatsapp 615 35 50 96
refer to the floating coin

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido