Bimar HR313 Operación Manual página 16

- the appliance is away from other sources of heat, flammable materials (curtains,
upholstery, etc.), flammable gases or explosive materials (spray cans) and materials that
can be deformed by heat.
OPERATION
The appliance's functions are activated using the remote control, which must be
pointed at the appliance's receiver (A) from below (max distance about 4m); at first
use, extract the clear plastic tab from the battery compartment (1 type CR2025
battery).
To replace the "CR2025" battery, move
the tab towards the centre "A" (use a
small screwdriver if necessary) and at
the same time extract the battery case
"B - C"; replace the battery (ensuring
that the polarity is correct) and re-
close the battery case "D".
If the remote control is unused for lengthy periods of time, remove the battery.
The device has the following adjustment and control functions and accessories:
•
Main switch 0/I (B) on the unit: when the switch is set in the "I" position the unit is
in standby and the red LED (A) lights on; when the switch is set in the "0" position
the unit is off.
•
" " key on the remote control (1): sets the unit in active mode or in standby
mode: in the latter mode, the red light is lit on.
•
Remote control button "
goes out; press the button again to deactivate the functions (red LED on).
•
Button (2): press to activate heating element at 500W
•
Button (3): press to activate heating element at 1000W
•
Button (4): press to activate heating element at 1500W
•
Key (5): lights up the orange LED light; press the key again to turn it off.
•
Shackle (E)
•
Metal chain (F)
•
Power supply cable (G).
Use
To start the appliance, connect the plug to the power socket: press the main switch on
the device into the I position and the red LED will come on (indicating standby state);
to activate the appliance, press the"
functions required.
To deactivate the device, press the "
To switch off the appliance, remove the plug from the power socket,
" (1): press to activate functions and the red LED
"button on the remote control and select the
" button on the remote control, switch on 0.
16