Mediclinics M092A Manual De Instalación Y Utilizacion página 16

D - Connect the electrical cables to the hand dryer's terminal strip. Connect the cables
corresponding to the two phases (N and L) and to earth in the corresponding sockets of
the terminal strip, as indicated by the engraved letters. When making these
connections contemplate means for disconnecting from the power grid with a minimum
contact separation of at least 3 mm (0,12") for all poles. These disconnection means
must be incorporated into the fixed installation. The hand dryer must be installed
against a solid surface only (wall, partition, or similar).
AIR HOSE CONNECT M092A
A – Place the wire through the adaptor tube cut, placing the gasket in the tube hole.
B – Place the clamp in the adaptor tube and connect it to the 'air unit'. Place the
adaptor tube as high as possible not forcing the wire. Firmly tight the clamp.
C – Connect the earth terminal.
AIR HOSE CONNECT M093A
A – Place the clamp in the adaptor tube and connect it to the 'air unit'. Firmly tight the
clamp.