Modes - Rollei 28031 Manual Del Usuario

Modes

Mixed mode
Grouping mode and parameter setting
1) Press the mode button repeatedly to select
the transmitter mode as mixed mode
(as shown in the picture) .
2) Press the group buttons (A, B, C, D) shortly to select or exit the flash group
setting . The group which can be set is indicated by an arrow .
3) If you have selected a group and it is indicated with the arrow, press the mode
button to set the group in the desired mode . This can be done for every group .
The modes are as follows:
TTL: Here the exposure compensation can be adjusted from -3 .0EV to +3 .0EV
(in total 22 levels) .
M: The flash output range is from 1/128 – 1/1 . Press the left and right button
to increase or decrease the value in 0 .3EV increments (22 levels) .
OFF: That means this flash group is not engaged and won't flash .
4) After all the parameter settings are done, press the group buttons (A, B, C, D)
to exit and sent all the information to the other flash units . Please note that
the flash units need to have the same channel as the transmitter .
27