Hvac Setup On Screen - Filtrete 3M-22 Manual De Instrucciones

HVAC Setup on Screen

IMPORTANT: Make sure the 3M-22 is powered up and the
mode switch is set to OFF. HVAC configuration switches must be
set first [pg 8].
• With mode in OFF, press HVAC button for 5 seconds to enter
SETUP.
• Use +/- icons to select HVAC SET UP number on screen.
The LCD display will show your selection and indicate the number
of stages you have selected. During setup, 2nd stage will blink
when both heat and cool have 2nd stages.
If you have a Normal HVAC system and you
want fast temperature recovery...
HEAT and COOL
2 stage HEAT, 1 stage COOL select
2 stage HEAT, 2 stage COOL select
If you want efficient [but slower] recovery...
2 stage HEAT, 1 stage COOL select
2 stage HEAT, 2 stage COOL select
NOTE: For 2 stage systems your 3M-22 can recover from a temperature setback in 2 ways: 1] Fast Recovery - This uses your 2nd
stage to bring the house to Target Temperature. Differential is 2
the 2nd stage to bring your house to within 3
If you have a HEAT PUMP HVAC system...
1
select
2 HEAT PUMP with AUX heat
3
HEAT PUMP with AUX heat
4
HEAT PUMP no AUX heat
5
o F. This may use slightly more energy. 2] Efficient Recovery -This uses
o
F of the target and then uses the 1st stage to go the last bit. This is more efficient.
(fast recovery)
(efficient recovery)
10 10
PG PG
CO OL
STAGE
HE AT
2
HVAC
SETUP
A
select
b
select
C
select