NuTone QTXEN Serie Manual Del Usuario página 3

Ocultar thumbs Ver también para QTXEN Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALL HOUSING & DUCT
1a. Mount
housing to
joist or I-joist.
Use a pliers to bend
housing TABS out
to 90
. Hold housing
0
in place so that the
housing tabs
contact the bottom
of the joist. The
housing mounts
with four (4) screws
or nails. Screw or
nail housing to joist
through lowest
holes in each
mounting flange,
then through
highest holes.
NOTE: Mounting to
I-JOIST (shown)
requires use of
SPACERS
(included) between
the highest hole of
each mounting
flange and the I-
joist.
1b.Mount housing anywhere between
trusses, joists, or I-joists using hanger
bars.
Sliding hanger bars are provided to allow for accurate posi-
tioning of housing anywhere between framing. They can be
used on all types of framing (I-joist, standard joist, and truss
construction) and span up to 24".
HANGER
BAR (4)
Attach the MOUNTING CHANNELS to the housing using the
SCREWS supplied. Make sure TABS face "up" as shown. Use the
set of channel mounting holes (marked "STD") to mount the hous-
ing flush with the bottom of the drywall. Use the other set of holes
(not marked) to mount the housing flush with the top of the drywall.
TABS
SPACER
(use for mounting to I-Joist)
I-JOIST
OR
SCREWS (4)
MOUNTING
CHANNEL (2)
HOLE FOR OPTIONAL
SCREW MOUNTING (4)
Extend HANGER BARS to the width of the framing.
Hold ventilator in place with the hanger bar tabs wrapping
around the BOTTOM EDGE OF THE FRAMING.
NAIL ventilator to framing or fasten with screws (not provided)
through HOLES near nails.
*
To ensure a noise-free mount: Secure hanger bars together
with SCREWS or use a pliers to crimp mounting channels
tightly around hanger bars.
2. Attach
damper/duct
connector.
Snap damper /
duct connector
onto housing.
Make sure
connector is flush
with top of
TAB
housing and
damper flap falls
closed.
3. Install
6-inch
round
ductwork.
Connect 6-inch
round ductwork
to damper / duct
connector. Run
ductwork to a
roof cap or wall
cap. Tape all
ductwork
connections to make them secure and air tight.
MODELS QTXEN050 • QTXEN080 •
QTXEN110 • QTXEN150
NAIL (4)
Page 3
*
SCREW (2)
BOTTOM EDGE
OF FRAMING

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Qtxen050Qtxen080Qtxen110Qtxen150

Tabla de contenido