Servicing - Techne TC-9D Manual Del Usuario

T C - 9 D O P E R A T O R ' S M A N U A L

Servicing

Before any servicing of the TC-9D is attempted the unit should be
disconnected from the mains.
In the interests of safety both of personal and of the instrument, maintenance
and repair work should be carried out only by trained electronic or electro-
mechanical technicians. Untrained personnel should not attempt to
dismantle the instrument.
CONTROLLER
To remove the controller push the side tabs out to unlock the
controller and slide it out of the sleeve. Replacement is the reverse
of this. For further details on the controller refer to the Eurotherm
operating instructions supplied.
SOLID STATE RELAY
Access is gained to the solid state relay by removing the two screws
securing it to the heatsink. Be sure to apply a thin layer of
thermal grease when replacing the relay.
17