Glass 1989 SAUNE Manual De Uso página 48

Press the ''MENU/OK''
m e s s a g e s a y i n g ' ' S A U N A _ O F F ' '
''Temperature_actual temperature''
appears on the display.
The temperature is set.
EN
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
programming.
FAN
(not supplied with the sauna)
If there is a fan installed in the sauna, it
can be connected to the control unit and
controlled by the command mentioned
above.
The fan speed can be set from 0 (off) to
100%.
NOTE: If there is no fan installed: select
0% = OFF
To go to the programming mode, use the
and button until the word ''Fan''
"MENU/OK" button. The display shows
"SAUNA_SET" "Fan_60%" or the value
previously entered.
Set the desired temperature with the
and buttons (e.g. 80%).
Press the ''MENU/OK''
message saying ''SAUNA _OFF'' ''Fan_
OFF'' appears on the display.
The fan status is set.
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
programming.
Turning the automatic mode on / off
The automatic mode can be activated after
the programming stage.
Press the
selection with the "MENU/OK" button.
The display will show a message saying
"SAUNA_SEND" "Automatic_ON" and
after a few seconds the confirmation
message "SAUNA_Automatic" appears,
switching to the "Start-Time_18:30"
and button until the
parameter.
The automatic mode is on. The system
starts heating at the set time.
To turn off the automatic mode, press
the and button until the the word
"Automatic" appears. Confirm the
selection with the ''MENU/OK'' button.
The display will show a message saying
''SAUNA_SEND'' ''Automatic_OFF'' and
after a few seconds the confirmation
message "SAUNA_OFF" "Automatic_
OFF" appears.
The automatic mode is off.
When the sauna turns off, an acoustic
signal is emitted and the display shows
a message saying "SAUNA_OFF" and
"Duration _STOP" appears in the session
duration parameter.
The programmed values are saved in the
control device until the next time they are
edited.
LIGHT BUTTON
By pressing the
on the lighting in the sauna, even when
the keypad is in "stand-by" mode. The
sauna will remain lit even if the session
To turn off the light press the
again.
16
button, you can switch
button