Sunbeam 157903 Manual Del Usuario página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note: there is a P to the right of the clock to denote PM.
4. Release the button to stop at the desired time.
5. When the desired time has been reached, slide the switch to the center position to save the time and return
to normal operation.
Note: The clock will blink until the time has been set.
The control will remember the time settings unless AC power is disconnected.
Selectable Auto Off:
You can set the auto-off time at 2hrs, 6hrs or 10hrs.
If the personalized options are not selected, the auto off feature is designed for conservation of energy by
automatically turning your blanket or mattress pad off after 10 hrs of continuous use.
To use the auto-off feature, Press the Mode button until the "Auto-Off" words begin to flash.
While the "auto-off" is flashing, use the + (dimmer increase) and - (dimmer decrease) buttons to scroll
through the 3 auto off options.
Auto off will be set at the highlighted time. (The control will remember the auto off setting unless AC power is
disconnected.
If no button is pressed after 6 seconds, the highlighted setting will be set.
Preheat:
The preheat function will heat the bed for a period of 30 minutes and the control will return to its original
setting.
Your controller allows you to set the time that you would like your blanket to start preheating each night. That
way you can always get into a cozy warm bed.
To set the preheat time with a set time
1. Make sure the clock has been set. To set the clock, please see the clock set instructions.
2. Set the time you would like the pre-heat to come on.
3. Turn the unit over to find the Slide switch. (if the clock has not been set, please see clock set instructions.)
4. Slide the switch to Preheat Time Set. The clock and "Preheat will flash". Press the + (dimmer increase) or
the – (dimmer decrease) buttons to scroll through the time. (if you hold down the button, the time will scroll
at a faster pace).
Note: there is a P to the right of the clock to denote PM.
4. Release the button to stop at the desired time.
5. When the desired time has been reached, slide the switch to the center position to save the time and return
to normal operation.
Note: The Preheat time will blink until you have set the Clock. Please set the Clock before you set the time you
would like preheat to start.
The control will remember the time settings unless AC power is disconnected.
To use the preheat function without setting the time
1. Press the mode button until Preheat flashes on the screen.
2. Press the + (dimmer increase) or – (dimmer decrease) to scroll through the options. Each press moves
changes the options as follows:
• Preheat On with the time displayed. This will set the preheat to turn on automatically at the pre-set time
displayed. If you do not press any button for 6 seconds, the preheat time will be set and the unit will be
ready to preheat at the set time.
• Preheat On without the time displayed. This will start the preheat when you leave the mode setting. You can
leave the mode setting by not pressing any button for 6 seconds.
• Preheat off. This stops any preheat functionality.
If no button is pressed after 6 seconds, the last setting will be stored.
10
For questions or support, please visit www.sunbeambedding.com.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido