Publicidad
Idiomas disponibles
Idiomas disponibles
[] Channel
Selection
Selectchannels by using [CH.• / V] or[the Numberbuttons].
Use [CH.•
/V]
or [the Number
buttons]
to select the
memorized
channels.
or
,
v j/
or
.7.L) ._
_9.L.
EN_
Using [the Number buttons]
-When
selecting
analog channel
12
- When selecting
digital
channel
12-1
ENT
• Be sure to press [-lENT.]
before entering
the minor
channel
number.
• Press [CH. RECALL _%] to return to the previously
viewed
channel.
• When you select a channel
larger than 100, press
[+100] first. Then use [the Number
buttons]
to press
the lower 2-digit numbers.
• Only [the Number
buttons]
can be used to select the
non-memorized
channels.
About
digital
TV broadcasting:
With its high definition
broadcast,
digital
broadcasting
far surpasses analog broadcasting
in both its picture
and sound quality.
What is the minor channel?
By using high compression
technology,
digital
broadcasting
offers a service that enables multiple
signals to send simultaneously.
Therefore,
you can
select more than one program
per major channel
since
digital
broadcasting
technology
distinguishes
between
multiple
channels broadcast
by a single network.
NTSC (analog mode)
[Air Time]
ATSC (digital mode)
18:00
18:30
19:00
19:30
20:00
20:30
major channel
minor channel
_I_ : change automatically
_> : change manually
by using [CH.A/V]
Although,
you cannot watch the high definition
TV
(HDTV) program,
the unit converts
the HDTV signal
down to the standard
definition
TV signal.
Note:
•"NO SIGNAL"will appear on the TVscreen after the minor
channel broadcast is over.
[] Volume
Adjustment
Thissection describes h owto adjustthevolume.
Themutefunction,whichturnsthe sound offand on,isalsodescribed.
Use [VOL. _ / _] to adjust the audio volume.
or v_.)
VOLUME
20
Illlll
..........
• The volume
bar will be displayed
at the bottom
of the
TV screen when adjusting
the volume.
• The volume
bar will automatically
disappear
in a few
seconds.
Press [MUTE o_] to turn offand
on the sound.
i <i
MUTE
MUTE
20
IIIIII
..........
• "MUTE" is displayed
on the TV screen.
Press [MUTE
_] again or use [VO/._/_]
to recover
the original volume.
i............
i<>
[] Switching
Each Input
Mode
Youcaneasilyswitch with the remotecontrol t o theDTV(ATSC) andTV
(NTSC) or toaccess e xternaldevices whentheyareconnected to theunit.
Press [INPUT] repeatedly
to cycle through
the input
modes.
'i !3!!
<:, .....
iiE:,,
ii <2>
ii . .....
INPUT
• To use the video or S-video input jack on the unit,
select "VIDEO1 ".
• To use the component
video input jacks on the unit,
select "VIDEO2".
• To use the PC input jack on the unit, select"PC".
Note:
•When you switch the analog mode to the digital mode,
it may take a while until the digital channel selection is
completed. "NOW SCANNING"is displayed while switching
the modes.
<2:
<:
EN
Publicidad
