Suitable for induction cooking
10
Operation
4.10 Operating the keys
In the procedure described below, the following key must
be activated within 10 seconds. If this is not the case, a
selection is no longer possible.
4.11 Switching on the induction hob and cooking
zone
1. Press the ON/OFF key
power setting 0 appears and a short signal will sound.
The controls are ready for operation.
2. The sensor fi eld
activated immediately afterwards. A power setting will be
switched on.
.......left Power setting 0.
.......center Power setting 6.
.......right Power setting P*
See the section on Worth knowing about the slider
(sensor fi eld)
Press the respective sensor fi eld
power setting or to switch on an additional cooking zone.
3. Immediately put cookware suitable for induction cooking
onto the cooking zone. The pan recognition device will
activate the induction coil. The pot or pan will be heated
up.
As long as no cooking pot is placed onto the cooking
zone, the display will alternate between the power level
set and the symbol
is placed on the cooking zone it will switch off after
10 minutes for reasons of safety. Please refer to the
Section on pan recognition.
4.12 Switching off a cooking zone
4. a) Press the sensor fi eld on the far left
b) drag your fi nger to the left across the touch control
to reduce the power setting to 0
c) press the ON/OFF key
switched off .
4.13 Switching off the induction hob
5. Press the ON/OFF key
switched off , irrespective of any settings.
NOTE
The hob will switch off automatically after 10 seconds
when all the cooking zones are switched of manually
(power setting 0) and no key/sensor fi eld is pressed
afterwards.
* The Power boost function is activated immediately.
See the section on Power setting.
(approx. 1 sec.) until the
of a cooking zone must be
to change a
for "No pot detected". If no pot
. All the cooking zones are
. The induction hob will be
GB
or