Yaesu G-1000DXC Manual De Usuario página 11

Mounting the Rotator and Antenna
I
NDOOR
A clear plastic round dial heading sheet is provided with the kit, which can be installed with north at any position you
desire. This is particularly useful when you need to have south at the top of the dial (or east or west) instead of north. To
install the heading scale:
Turn on the POWER switch and press the seesaw switch
to set the indicator needle to 0° (straight up), then turn off
the POWER switch.
Grasp the edge of the bezel around the bearing window,
turn it 10° counter-clockwise, and pull it off.
Note the position of the needle, then grasp it at its center,
and pull it straight off.
Determine which compass direction you desire to be upmost,
and install the compass heading label sheet against the azi-
muth scale, so that the small teeth in the edges of the sheet
lock around the edge.
Replace the needle and bezel in the same direction as they
were before (see diagram at the right).
Perform this procedure only if it is not possible to align the PRESET knob tracking using the PRESET ADJ A and
PRESET ADJ B potentiometers on the rear panel, as described in steps 12 ~ 14 on the previous page.
Pull off the PRESET control knob.
Set the potentiometer shaft to the fully counter-clockwise
position, then turn it 30° clockwise.
Using care not to disturb the PRESET potentiometer, push
the knob back on the shaft so that the knob stopper is aligned
with the counter-clockwise edge of the slot in the panel be-
hind the knob, as shown in the drawing to the right.
Repeat steps 12 and 13 on the previous page for the PRE-
SET Dial Tracking Alignment.
Do not forget to set the SELECT SWITCH on the rear
panel to the left (
OPERATION MODE
ment.
G-1000DXC/-2800DXC User Manual
P C
ERFORMANCE
Installing the Dial Heading Sheet
PRESET Knob Calibration
) position after align-
A
HECK AND LIGNMENT
Azimuth Indicator Needle
Bezel
Stopper Limit
Potentiometer Shaft
Knob
Dial Heading Sheet
30°
Stopper
Page 9