Hilti RT 6-A22 Manual De Instrucciones página 25

Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
9.1 Blind-rivet setting tool is not in working order
Malfunction
The LEDs do not light up.
1 LED flashes.
4 LEDs flash.
Overload LED flashes for 10
seconds.
Blind rivet is not set.
No rivet mandrel disposal.
*2225140*
Printed: 30.07.2019 | Doc-Nr: PUB / 5466619 / 000 / 02
Possible cause
The battery is not fully inserted.
The battery is discharged.
The battery is too hot or too cold.
The battery is discharged.
The battery is too hot or too cold.
Product momentarily overloaded.
Protection against overheating.
Overload protection.
The battery is discharged.
Jaws are dirty or worn.
Jaw housing not correctly screwed
on.
Spring weak or defective.
Use of the wrong nosepiece.
Nosepiece is worn.
Rivet mandrel wedged in jaws.
Steel sleeve is dirty.
Mandrel container is full.
2225140
Action to be taken
▶ Push the battery in until it
engages with a click.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
▶ Release the control switch and
then press it again.
▶ Allow the product to cool down
and clean the air vents.
▶ Remove metallic residues .
→ page 19
▶ Change the battery and charge
the empty battery.
▶ Clean the jaws or, if applicable,
→ page 19 replace them.
▶ Screw the jaw housing on
correctly . → page 20
▶ Replace the spring . → page 19
▶ Change the nosepiece .
→ page 19
▶ Change the nosepiece .
→ page 19
▶ Remove the rivet-mandrel
residues from the jaw housing .
→ page 19
▶ Clean the steel sleeve .
→ page 19
▶ Empty the mandrel container .
→ page 19
English 21