First Starting - Glass 1989 POP Serie Manual De Uso

Before fixing the inspection panel, set up the wishes temperature of the water,
adjusting the trimmer on the heater element.
38
30 45
°C
- After the installation, check that the bathtub is clean. Fill it up with water at 40+/-5°C
up tp the highest jet level that allows the system functioning.
- Make sure that water has covered the jets.
- Make sure that the jets are open, otherwise turn the diffuser anticlockwise (only if
available on the model).
- Start the system and let it running for 10 minutes minimum. Without draining the
bathtub, stop the hydromassage system and after 10 minutes minimum, check all
the piping, the joints and the connections to find any water leaks.
HEATER
(only if available on the model)
WARNING

FIRST STARTING

WARNING
5
EN