Glass 1989 POP Serie Manual De Uso página 24

AIRPOOL, WHIRLPOOL AND SANITIZING FUNCTION
EN
1. WHIRLPOOL ON/OFF operation light.
2. WHIRLPOOL button.
3. AIRPOOL operation light.
4. AIRPOOL ON/OFF button.
5. AIRPOOL intensity adjuster light.
6. AIRPOOL intensity regulation button.
- fill the bathtub up to the highest jets level
that allows the system functioning.
- The AIRPOOL and WHIRLPOOL
systems duration is pre-set for 15 minutes
and it can not be changed.
WHIRLPOOL FUNCTION
To start the whirlpool function, push
the button (2). The "whirlpool system
functioning" green led will light up.to stop
the whirlpool function before the end of
the set time, push again the same button.
Hydromassage intensity is fixed.
"Flashing red led" indicates water missing;
fill further the bathtub over the level of
the jets.
AIRPOOL FUNCTION
(only if available on the model)
To start the airpool function, push the
button (4). The "airpool system functioning"
green led will light up.to stop the airpool
function before the end of the set time,
push again the same button.
"flashing red led" indicates water missing;
fill further the bathtub, over the level of the
jets. if there is no water, the airpool does
not work.
The airpool system starts the cycle at the
maximum intensity. the airpool intensity
6