On-Surface Installation - Alpha IP RTD 61001 Serie Manual De Instrucciones

Commissioning

5.2.1 On-surface installation

Ö Select an appropriate installation position.
1. Ensure that the installation position is free from hidden lines.
2. If necessary, release the device from the installation bottom with a suitable screw-
driver (see fig. 3 page 5).
3. Hold the installation bottom to the installation position. Take care to align the
installation bottom correctly.
4. Align the installation bottom horizontally.
5. Mark two diagonally opposite bore holes using the installation bottom (see fig.
2a page 4).
If wood walls are present, the screws can be screwed directly into the
wood. Pre-drilling with a 1.5 mm wood drill can facilitate the installation
of the screws.
6. For stone walls, drill the holes at the marked positions with a 5 mm masonry drill.
7. Insert dowels into the bores.
8. Install the installation bottom using the supplied screws.
9. Position the device onto the installation bottom and latch it in (see fig. 3 page 5).
42