Installation In Flush-Type Box; Installation With Adhesive Strips - Alpha IP RTD 61001 Serie Manual De Instrucciones

5.2.2 Installation in flush-type box

The fixing holes on the installation bottom can be used for installation on a flush-
type box.
1. If necessary, release the device from the installation bottom with a suitable screw-
driver (see fig. 3 page 5).
2. Align the installation bottom horizontally on the flush-type box.
3. Install the installation bottom with suitable screws (see fig. 2b page 4).
4. Position the room control unit Display onto the installation bottom and latch it
into the clips (see fig. 3 page 5).

5.2.3 Installation with adhesive strips

Depending on the ground, installation can be performed using the supplied dou-
ble-sided adhesive tapes. Installation is possible on different grounds, as e. g. ma-
sonry, furniture, tiles or glass.
If the installation is done with adhesive strips, the installation surface must
be smooth, level, undamaged, clean, and free from grease and solvents.
1. Select an appropriate installation position.
2. Remove the protective foil from one side of the adhesive strip.
3. Fix the adhesive strip on the back side of the installation bottom in the recesses
provided for this (see fig. 2c page 4).
Commissioning
43