Complete Assembly - Gladiator GAJG36FDYG Instrucciones De Ensamblaje

4c.
Install Shelves
P1
A
A. Magnet facing outward
Repeat steps 2 and 3 for the remaining two shelves (P5mr). The
magnet for shelves (P5mr) is located on the right-hand side and
facing out, as shown below.
NOTE: Make sure the magnet on the right side of each long shelf
edge is facing out.
Adjust the Shelves
1. Lift up on the underside of the shelf until the shelf tabs are free
of the cabinet slots.
2. Tilt the shelf up to reposition it within the cabinet or to remove
it from the cabinet.
1. Make sure there is a bolt or screw in each hole of the cabinet frame.
2. Move the cabinet to its final location.
3. Place a level on an inside shelf, and if necessary, level the cabinet by adjusting the height of the leveling legs. Turn to the left to raise
or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching the door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.
6
P2
P5mr
P1
P5ml
P5mr
P3

Complete Assembly

5.
Install Doors
F3c Phillips-head screw (12)
P2
P1
P5mr
P5ml
P7
A
P5mr
P3
A. Phillips-head screws
IMPORTANT: The door with the lock assembly (P7) should be
installed on the right-hand side of the cabinet. The door hinges
are designed with keyhole slots at the top and bottom so the door
will hang on the cabinet while you are fastening the screws.
Start Phillips-head screws (F3c) in both the top and bottom holes
on each side of the cabinet. Hang the right-hand side door (P7)
from the top and bottom screws, and hand tighten. Insert the
middle four screws through the door hinge into the cabinet and
hand tighten. Repeat steps 2 and 3 to attach the left-hand door
(P6). Align the doors and completely tighten the door screws.
F3c