Installation Instructions - Gladiator GAJG36FDYG Instrucciones De Ensamblaje

1.
Install GearWall
GearTrack
®
18" (46 cm)
IMPORTANT: Gladiator brand Premier Jumbo cabinet is designed
to be installed on Gladiator
channels. If GearTrack channels will be used to support the
®
Gladiator Premier Jumbo GearBox cabinet, you must use three
®
channels installed 18" (45.72 cm) apart. Be sure the GearWall
panels or GearTrack channels are installed with mounting screws
®
in every slot and at every stud location with a maximum of
24" (60.96 cm) horizontally between screws.

INSTALLATION INSTRUCTIONS

Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
panels or
®
channels
GearWall panels or GearTrack
® ®
WARNING
Excessive Weight Hazard
2a.
Attach Mounting Brackets
F7 Carriage-head bolt (9)
F8 Washer (9)
®
®
P8
IMPORTANT: There are slots in back panels (AAA, CCC, and
DDD) to attach the mounting brackets (P8).
With the mounting bracket rim pointing down, align the three
bracket holes with the slots in back panel (AAA), as shown.
Working from the back, insert carriage bolts (F7) through the
bracket and into top back panel (AAA). Working from the cabinet
interior, fasten each bolt with a washer (F8) and a flange nut (F2).
Fully tighten the bolts.
F7 F8
F2 5/16" flange nut (9)
P2
AAA
P1
BBB
A. Bracket rims pointing down
F2
AAA
P1
P8
A
7