Troubleshooting - Warm House Bern Manual De Operación

Troubleshooting

Unit does not work / does not heat
No flame effect
Replacing the Light Bulb

This fireplace consists of 2 bulbs (E-12, 40W) that illuminate a flame effect. The light bulbs need
to be replaced if you notice a dark section of the flame or when the flames lose clarity.

Warning - Always disconnect from the power outlet before removing bulbs to reduce the risk of
fire, electric shock or damage to property.

Warning - The bulb reaches high temperatures during operation. Allow it to cool down before
replacing it.

Access the bulb panel located on the rear panel of the fireplace (see below figure).
Problem Possible Solution
· Check if the unit is plugged in the power outlet.
· Check if the unit is in Standby mode. If so, turn
the unit ON.
· Check if the heat is turned OFF.
· Check for safety cut-off operation.
· Check if the unit is plugged in the power outlet.
· Check if the unit is in Standby mode. Turn the
unit ON.
5