SOUNDMASTER SCD1990SW Manual De Instrucciones página 16

1. Select the RADIO mode with the "STANDBY / FUNCTION" button, until "FM" is shown in the
display.
2. For FM reception: Completely extend the telescopic antenna. Change its position to improve
the reception.
3. There are two options to search for and preset radio stations.
•
Automatic scan:
Important! Any preset radio stations will be overridden.
Press and hold the "AMS / MODE" button for approx.3 seconds. The system scans the
entire frequency band for radio stations. Any stations found will be preset from lowest to
highest frequency.
•
Manual scan for audio stations:
Briefly press the "SKIP+ / TUNING+" & "SKIP- / TUNING-" buttons, until you have found the
radio station which you are looking for. If you keep one of the buttons pressed down, the
device will search to the previous, respectively next radio station.
Preset station:
1. Press and hold the "AMS / MODE" button on unit for about 2-3 seconds to start the
automatic preset process.
2. Display will show the memory sequence number and radio stations will be automatically
preset into the sequence number (Note: Each sequence number means 1 preset station
while during automatic preset process.)
3. Once all the stations were automatic preset, press the "PRE. / FOLDER" button to choose
preset stations.
Info display
Press the "INFO" button to show the FM information.
FM Menu
In FM mode, press the "STOP/MENU" button to enter the FM menu.
The FM menu is divided into menus: Scan setting, Audio setting and System.
•
Scan setting: Select the desired option for automatic station search.
- All stations: Search for all stations that can be received. In this case, station search also
stops for weak stations.
- Strong stations only: Only clear stations are searched.
•
Audio setting: Select the MONO or STEREO for FM reception.
•
System
•
Language
•
Time Update
•
Factory Reset
•
SW version
SCD1990SW / English Instruction Manual
FM
5