Easy Steps To Operate Your Angelcare; Monitor - Angelcare AC200 Manual De Instrucciones

Figure 1
NURSERY UNIT (TRANSMITTER)
Antenna
Low battery indicator
(flashing orange)
Microphone
Adapter
socket
Backup battery compartment

4 EASY STEPS TO OPERATE YOUR ANGELCARE

STEP 1. NURSERY UNIT (TRANSMITTER)
• Insert 4 AAA batteries into Nursery Unit (for battery backup in case of power failure).
• Connect AC adapter to Nursery Unit and plug adapter into an electrical outlet.
STEP 2. PARENTS UNIT (RECEIVER)
Model AC200: Insert 4 AAA batteries into Parents Unit. Or, connect AC adapter to Parents Unit and plug adapter to an electrical outlet.
Model AC200-R: The pre-installed Ni-Cad rechargeable batteries need to be charged for 15 hours continuously before first-time use.
To charge, connect the AC adapter to the Parents Unit. Plug AC adapter to an electrical outlet (Figure 4). The batteries will charge as long as it
is connected to a powered AC adapter. The position of the switches will not effect charging.
For longest battery life, only recharge the Parents Unit when the orange Low Battery light flashes.
NOTE: Only the Parents Unit is rechargeable in Model AC200-R.
• Adjust the volume control to the desired level.
STEP 3. TO USE MONITOR
Place baby in crib and switch both units ON by selecting either channel A or B. If reception is not clear, switch to other channel.
Make sure both units are on the same channel.
To avoid feedback (whistling sound), keep both units at least 3 meters apart (10 feet).
STEP 4. BATTERY MODE
• When unplugging AC adapter from each unit, make sure unit is switched OFF. Otherwise, unit will revert to battery mode.
• The monitor will revert automatically to battery mode during a power failure. Insert batteries into Nursery Unit and Parents Unit
for Model AC200. When orange Low Battery indicator flashes, change batteries promptly (or recharge Parents Unit for Model
AC200-R).
Note:
• Test your Angelcare ® monitor BEFORE first-time use and then on a periodic basis.
• The Angelcare ® monitor is perfectly safe. The Nursery Unit emits only very low power radio signals through its antenna. These
signals do not present a safety hazard.
• If you have questions or need help, please call your distributor, see page 32.
Figure 2
Power On/Off &
Channel A or B selector
Power On indicator (green LED)
Nursery Unit
PARENTS UNIT (RECEIVER)
Antenna
Power ON indicator
(green LED)
Volume control
selector
Sound level
indicators
(red LEDs)
TM
Speaker
Adapter
socket
Parents Unit
Figure 3
Low battery
indicator
(flashing orange)
Battery comparment
Power ON/OFF &
Channel A or B
Bottom view of
selector
Parents Unit
Figure 4
9 Volt AC Adapters (2)
®

MONITOR

®
3