Care And Maintenance - Dandy Designer DBC93BLSDD Guía Utilice Y Cuide Del Propietario

SHELF INSTRUCTIONS
IMPORTANT
Do not cover any part of the rack with aluminum foil or any other
material that will prevent adequate air circulation within the unit.
To remove a rack from its locked position, lift the rear of the rack upward and then slide the rack out from the unit, as
shown in Fig. E.
To re-install, ensure the rack is resting securely on the support brackets, and push the rack inward until it locks into
place.
Allow the beverage center door to remain open for a few minutes after manual cleaning to air out and dry the inside of
the beverage center.
NOTE: Be certain the power is off before cleaning any part of this appliance.
HOW TO CLEAN THE INSIDE
Never use any commercial or abrasive cleaners or sharp objects on any part of the beverage center.
Walls, Floor, Inside Window, and Shelves:
Some water deposits and dust can be removed with a dry paper towel, others may require a damp cloth.
HOW TO CLEAN THE OUTSIDE
Do not use cleaners containing ammonia or alcohol on the beverage center. Ammonia or alcohol can damage
the appearance of the appliance.
Outer Case:
It's important to keep the area clean where the door seals against the unit. Clean this area with a sudsy cloth. Rinse and
then dry.
Door surface:
Use only mild, non-abrasive detergents applied with a clean sponge or soft cloth. Rinse well.
Control Panel and Door:
Wipe with a damp cloth and dry thoroughly. Do not use cleaning sprays, large amounts of soap and water, abrasive or
sharp objects on the panel they can damage it. Some paper towels may also scratch the control panel and door glass.
OPERATING INSTRUCTIONS

CARE AND MAINTENANCE

Fig. E
8