Changing The Radio Station; Scanning For Dab Stations - Fusion Apollo RA770 Guia De Inicio Rapido

2
Select the region you are in.

Changing the Radio Station

1
Select an applicable source, such as FM.
2
Select repeatedly to move through the tuning modes, and select an
option:
• Select Auto to scan and stop on the next available station.
• Select Manual to select a station manually.
• Select Preset to select a saved station preset.
3
Select or to tune to the station.

Scanning for DAB Stations

Before you can scan for DAB stations, you must connect a compatible DAB
module and antenna (not included) to the stereo. Because DAB signals are
broadcast in select countries only, you must also set the tuner region to a
location where DAB signals are broadcast.
1
Select the DAB source.
2
Select to scan for available DAB stations.
When scanning is complete, the first available station in the first ensemble
found begins playing.
NOTE: After the first scan is complete, you can select
DAB stations. When the re-scan is complete, the system starts playing the
first station in the ensemble you were listening to when you started the re-
scan.
Changing DAB Stations
1 Select the DAB source.
2
If necessary, select to scan for local DAB stations.
3
Select or to change the station.
When you reach the end of the current ensemble, the stereo automatically
changes to the first available station in the next ensemble.
Quick Start Manual
FUSION PartyBus
The FUSION PartyBus networking feature allows you to connect multiple
compatible stereos and zone stereos together on a network, using a combination
of wired or wireless connections.
A FUSION PartyBus device connected to the network can stream sources from
and control media playback on another FUSION PartyBus device connected to
the network.
You can connect up to eight FUSION PartyBus devices on a network.
In the image above, a Apollo
again to re-scan for
and to two Apollo SRX400 zone stereos
PartyBus zone stereo to a single speaker zone
PartyBus stereo to multiple speaker zones
FUSION PartyBus devices connected to the network can stream media from and
control media playback on other devices on the network, but cannot control the
volume of other devices on the network. You can adjust the volume of speakers
or speaker zones connected to the stereo only.
Streaming from a FUSION PartyBus Device on the Network
Before you can stream from a device on the network, you must set up and
configure your FUSION PartyBus devices according to the installation
instructions.
Networking
™
™ RA770 stereo connects to a wireless router
. You can connect a FUSION
. You can connect a FUSION
to cover a larger area.
5