Setting And Using The Alarms - HoMedics SoundSpa Fusion Manual De Instrucciones E Información De Garantía

5. Turn the VOLUME KNOB on the unit to adjust the system volume
(Fig. 1).
6. To turn off the unit, press the POWER BUTTON.
Using Auto-Timer
While listening to your iPod, the nature sounds, or the radio, you may set a
timer so the unit will turn off automatically after so many minutes.
1. Toggle through the TIMER BUTTON until the time of your choice, 15, 30, 45,
or 60 minutes, is shown on the LCD.
2. To cancel the timer, toggle through the TIMER BUTTON until OFF is
shown on the LCD.

Setting And Using The Alarms

Setting Alarm1 or Alarm2 (Individually)
1. Press the AL1/AL2 button (Fig. 1). The AL1 or AL2 ICON will appear in
the upper right corner of the LCD display to indicate which alarm is
activated.
2. Press the AL SET BUTTON twice (Fig. 1); hour digits will begin flashing.
Turn the SET +/- KNOB until the desired hour is displayed. Remember to
set the correct time of day, AM or PM (an icon to the left of the time
display is the PM INDICATOR; there is no AM indicator) (Fig. 2).
3. Press the AL SET BUTTON again; minute digits will begin flashing. Turn
the SET +/- KNOB until the desired minute is displayed.
4. Press the AL SET BUTTON again to exit the alarm setting mode or after
5 seconds the display will stop flashing to indicate the alarm is set.
Note: You can press the AL SET BUTTON at any time to review the
alarm setting.
1 2
5. Toggle through the AL MODE BUTTON until the corresponding icon
lights on the LCD screen for the wake mode of your choice: iPod,
sound, radio, or beep (Fig. 2).
Note: To wake to iPod, your iPod must be properly docked in the
unit, or alarm will default to beep wake mode.
Note: When using the sound mode, the unit will set to the last
sound you listened to. If you wish to change it, first, press the
POWER button to turn the unit on, then press the SOUND button
and toggle through until the sound of your choice is shown on the
LCD display, then press the POWER button to turn the unit off.
6. When the alarm is sounding, press the POWER BUTTON on the unit to
turn the alarm OFF. The alarm will come on again at the same time on
the next day.
7. To stop the alarm from coming on the next day, press the AL1/AL2
BUTTON until the AL1 or AL2 icon disappears on the LCD display. If the
icon disappears, this indicates the alarm is disarmed.
Note: If the alarm sounds for 30 minutes continuously it will
automatically turn off and reset for the next day.
Setting Alarm1 and Alarm2 (Together)
1. Press the AL1/AL2 button (Fig. 1) until both AL1 and AL2 icons appear
in the upper right hand corner of the LCD display to indicate that both
alarms are activated (Fig. 2).
Note: You cannot change the alarm time when BOTH alarms are
selected. If you need to change the alarm time for either alarm,
follow step 1 under Setting Alarm 1 or Alarm 2 (Individually).
1 3