Adjusting Bass And Treble; Setting And Using The Alarms - HoMedics iSoundSpa Max Manual De Instrucciones E Información De Garantía

Listening to Nature Sounds
1. Press the POWER BUTTON (Fig. 1) on the unit to turn it on.
2. Toggle through the SOUND BUTTON (Fig. 1) on the unit until you reach
the nature sound you wish to listen to. The SOUND ICON will appear on
the lower bottom of the LCD to indicate which nature sound has been
selected (Fig. 2).
3. Turn the VOLUME KNOB (Fig. 1) on the unit to adjust the system volume.
4. To turn off the nature sounds, press the POWER BUTTON to turn the unit
off, or switch the audio mode by pressing the AUDIO BUTTON (Fig. 1).
Note: When the unit is turned on, it will always default to the
last mode used.

Adjusting Bass and Treble

It is recommended that you adjust the bass & treble while listening to the
iSoundSpa Max.
1. Press the BASS BUTTON (Fig. 1) on the unit. The BASS ICON will appear
on the left side of the LCD (Fig. 2) to indicate the bass is selected and bass
level will appear on the LCD display.
2. While bass level appears on LCD display, turn the SET +/- KNOB (Fig. 1) on
the unit to adjust the bass (from -8 to 8). After 5 seconds the BASS ICON
and bass level will disappear to indicate the bass level is set.
3. Press the TREBLE BUTTON (Fig. 1) on the unit. The TREBLE ICON will
appear on the left side of the LCD (Fig. 2) to indicate the treble is selected
and treble level will appear on the LCD display.
4. While treble level appears on LCD display, turn the SET +/- KNOB (Fig. 1)
on the unit to adjust the treble (from -8 to 8). After 5 seconds the TREBLE
ICON and treble level will disappear to indicate the treble level is set.
1 2
Using Auto-Timer
While listening to your iPod, the nature sounds, or the radio, you may set a
timer so the unit will automatically turn off.
1. Toggle through the TIMER BUTTON (Fig. 1) until the time of your choice, 15,
30, 45, or 60 minutes, is shown on the LCD.
2. To cancel the timer, toggle through the TIMER BUTTON until OFF is
shown on the LCD.

Setting And Using The Alarms

Setting Alarm1 or Alarm2 (Individually)
1. Toggle through the AL1/AL2 BUTTON (Fig.1) located on the top of the
unit to AL1 or AL2. The AL1 BELL or AL2 BELL ICON will appear in the
upper right corner on the LCD display to indicate which alarm is
activated (Fig. 2).
2. Press the AL SET BUTTON (Fig. 1) twice; hour digits will begin flashing.
Turn the SET +/- KNOB (Fig. 1) until the desired hour is displayed.
Remember to set the correct AM or PM (an icon to the left of the time
display is the PM INDICATOR; there is no AM indicator) (Fig. 2).
3. Press the AL SET BUTTON again; minute digits will begin flashing. Turn
the SET +/- KNOB until the desired minute is displayed.
4. Press the AL SET BUTTON again to exit the alarm setting mode or after
5 seconds the display will stop flashing to indicate the alarm is set.
Note: You can press the AL SET BUTTON at any time to review the
alarm setting.
1 3