Unit Operation; Key Function - Fracarro KDSR Instrucciones De Uso

and are used to keep all modules separated at an equal distance. The output signal is already filtered and
amplified with a variable level (adjustable by a step of 1 dB by the TPE programmer).
SUMMARY OF THE RANGE:
MODEL MODULATOR TYPE
KDSR QPSK receiver with VSB E2-E69 modulator, PAL B/G standard, audio mono
KDSR-S QPSK receiver with VSB E2-E69 modulator, PAL B/G standard, audio stereo
KDSR-M QPSK receiver with VSB E2-E69 modulator, multistandard (PAL I, N, H,...)
KDSR-AV QPSK receiver with A/V outputs on RCA connector
Connect the receiver to a KP K series feeder and wait until the green LED starts to flash; this means that the
module reset (bootstrap) is completed and the module is ready to be used; connect TPE.
Summary table of the LEDs status:
LED status
Red LED
Fixed green LED
Flashing green LED
Green LED Off
To program and display the internal state of KDSRs, use the TPE universal programmer. Connect the programmer
to the RJ45 outlet on the module front panel; TPE will switch on automatically.
IMPORTANT: to save the set parameters, press the TPE "S" key. If you don't press the S key within 5 minutes
from the last change, the set data will be lost.
The following are the programming menus of KDSRs
TPE keys
......

3. UNIT OPERATION

Reason
Module in error. To restore the proper operation, disconnect and reconnect the power
cable. Contact the nearest assistance centre if the problem continues.
The receiver is working properly, the transponder is received correctly, and the
front-end and MPEG decoder are both working properly.
The receiver is not detected
- the receiver is not power supplied
- the module is broken
- the module is booting up (wait a few seconds)
4. PROGRAMMING THE MODULE
To confirm an entered value or to select a menu
To cancel an entered value or exit a menu
12

Key Function

To scroll through menu items
To enter values
To save the modifications