Fracarro KDSR Instrucciones De Uso página 17

Select the language
TPE SETUP
Select the
BAUD RATE 485
communication rate of
the 485 port
Select the
communication rate of
BAUD RATE 232
the 232 port (not active)
TPE waiting time for the
answer of the controls sent to
the headend (timeout value
must be 30)
Regulation of the TPE
CONTRAST LCD
display contrast
Restore the TPE default
settings
Confirm the settings by pressing the
5.6 HEADEND SETUP AND KTP EMULATION MENU
Navigation in the headend
programming menus
HEADEND
NAVIGATION
SETUP
On Screen Display settings
NAVIGATION OSD
visualization
Automatic
acknowledgement of the
HEADEND SCAN
headend connected to
the TPE
Export the headend
configuration to another one
Restore the module
FACTORY SETUP
defaults setting
Setting the module
SET ADDRESS
address
Restart the module RESET MODULE
Emulation of the KTP
programmer
KTP
EMULATION
Confirm the settings by pressing the
5.5 TPE SETUP MENU
LANGUAGE Italiano
9600
9600
TIMEOUT COM
SI=V
RESET?
key; save the settings by pressing the
S key after the modules programmation.
KDSR
KDSR
Search module....
Copy
COPY KDSR
By means of the copy function, among modules of the same type, you can copy
the following input parameters: LNB, DiSEqC tone, IF freq. and Symbol rate. The
copied output parameters are the following: output channels, video format, RF
KDSR
The factory setup function restores the following factory parameters: LNB,
DiSEqC tone, IF freq., Symbol rate and visualized channel. The restored
output parameters are the following: output frequency, output channel, video
format, RF level, video test, audio type and audio level.
Address
KDSR
KTP Emulation
KTP
EMULATION
key; save the settings by pressing the
S key after the modules programmation.
17
English
Italiano
Deutsch
English
Français
Espanol
Portuguese
9600
19200
115200
38400
57600
115200
9600
19200
115200
38400
57600
115200
Increase/decrease from TPE by
using the arrow keys, or enter
1 30
the value directly from the
keyboard.
Increase/decrease fromTPE by
using the arrow keys or enter
0 31
the value directly from the
keyboard.
NO=X
Refer to the KDSR general
programming menu
Refer to the KDSR general
programming menu
Automatic search of the headend or
the connected device. After
searching, the main menu can be
seen from the NAVIGATION function
Paste
KDSR
YES = V NO = X
level, video test, audio type and audio level.
Yes=V NO=X
The function allows for the setting of a
new address that will be enabled after
the following module scanning.
All
Yes=V NO=X
modules
The function is not available
for the programming of the
V=OUTPUT
KDSR module
*