Measurmentoperation - koban KTIR-1050 Manual De Operación

KTIR-1050
Non-Contact Infrared Thermometers
To set values for the High Alarm (HAL), Low Alarm (LAL)
and Emissivity (EMS), firstly active the display by pulling the
trigger or pressing the MODE button, then press the MODE
button until the appropriate
left corner of the display, press the UP and down buttons to
adjust the desired values.
6. MEASURMENT OPERATION
① Hold the meter by its Handle Grip and point it toward the
surface to be measured.
② Pull and hold the Trigger to turn the meter on and begin
testing. The display will light if the battery is good. Replace
the battery if the display does not light.
③ While measuring, the SCAN display icon will appear in
the upper left corner of the LCD.
④ Release the Trigger and the HOLD icon will appear on
the LCD indicating that the reading is being held.
⑤
The meter
approximately
released.(Unless the unit is locked on)
12
will automatically
7 seconds
code appears in the lower
power
after the
www.grupotemper.com
off after
trigger is