Maytag Precision Touch 750 Serie El Manual Del Propietario página 16

Semf-C ean Oven
- It is normal for parts of the range to become hot during a
is add-resbtant, not acid-proof. The porcelain finish may
discolor if acidic spills are not wiped up before a self-
clean cycle.
o To prevent damage to oven doors, do not attempt to open
the doors when "Lock" is displayed,
- Avoid touching cooktop, doors, windows or oven vent
area during a clean cycle.
- Do not use commercial oven cleaners on the oven finish
or around any part of the ovens. They will damage the
[inish or aarts
* Do not leave baking/pizza stone in the oven during
self-clean.
The self-clean cycle uses above-normal cooking temperatures
to automatically clean the oven interior.
It is normal for flare-ups, smoking, or flaming to occur during
cleaning if the oven is heavily soiled. It is better to clean the
oven regularly rather than to wait until there is a heavy build-
up of soil in the oven.
During the cleaning process, the kitchen should be well
ventilated to get rid of normal odors associated with cleaning.
Before Se f-Cmeaning
1. Turn off the oven light before cleaning. The light may burn
out during the clean cycle.
2. Remove broiler pan, all pans, and oven racks from the
oven. The oven racks will discolor and may not slide easily
after a self-clean cycle if they are not removed.
3. Clean oven frame, door frame, area outside of gasket, and
around the opening in the door gasket with a nonabrasive
cleaner such as Ban Ami* or detergent and water. The
self-cleaning process does not clean these areas. They
should be cleaned to prevent soil from baking on during
the clean cycle. (The gasket is the
seal around the oven door and _ _
window.} _ ....
4. To prevent damage, do not clean or
rub the gasket around the oven
door. The gasket is designed to
seal in heat during the clean cycle.
5. Wipe up excess grease or spillovers from the oven bottom.
This prevents excessive smoking, flare-ups or flaming
during the clean cycle.
6. Wipe up sugary and acidic spillovers such as sweet
potatoes, tomato, or milk-based sauces. Porcelain enamel
Notes:
° Oven temperature must be below a00° F to program a
clean cycle.
, Only one oven can be cleaned at a time.
° Both oven doors lock when either oven is being
cleaned.
TO set Self-Clean:
1. Close the oven door.
2. Press the Clean pad.
° "Clean" and "SEt" flash in the display.
If the door is not closed within 25 seconds, the self-
cleaning operation will be canceled and tile disp
return to tile time of day.
3. Press the More+ or Less- pad.
° "MEd" for medium amount of soil {3 hours}
appears
If tile door is not closed, "door" will appear in
the display. After 45 seconds, three beeps will
sound, the self-cleaning operation will be canceled
and the display will return to the time of day.
4. Press the More+ twice for heavy soil (a hours}.
° "HVy" wiii be displayed.
Press Less- pad twice for light soil (2 hours}.
, "LITE" wiii be displayed.
Choosing the soil level of the oven automatically programs
the self-cleaning time. "Lock" flashes in the display.
5. After four seconds, the oven wiii start cleaning.
, The cleaning time wiii start counting down in the display.
, "Lock" wiii appear in the display and wiii flash until the
doors are locked. "Lock" wiii then remain lit.
° "Clean" wiii remain lit in the display.
To Delay a Self-Clean Cycle:
1. Press the Delay pad once for upper
oven and twice for lower oven.
° "dLY" flashes.
° "0:00" flashes in the display.
Press the More+ or Less- pad to set the
amount of time you want to delay the
cycle. Delay time can be set from ten minutes
{10:00} to 11 hours, 59 minutes {11:59}.
conto
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
15