Product Maintenance - Fellowes Fortishred 1050HS Manual De Instrucciones

ADVANCED PRODUCT FEATURES
SilentShred™ Technology
without noisy disruptions
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However,
on rare occasions the sensors may become blocked by paper dust causing the
motor to run even if there is no paper present
located in the center of the paper entry).
TO CLEAN THE SENSORS
1
2
Locate Auto-start
shredder
infrared sensor
TROUBLESHOOTING
Safety Shield Indicator: When flashing alternatively with On/Off ( )
Door Open Indicator: When flashing alternatively with On/Off ( )
Paper Capacity Indicator: When flashing blue, too much paper is inserted. Shredder will automatically stop and reverse paper. If necessary, press (R) to run shredder in
reverse. See Paper Jam section below.
R
Overheat Indicator: When flashing alternatively with On/Off ( )
PAPER JAM
2
1
Gently pull uncut paper
When flashing red,
from paper entry.
too much paper is
inserted. Shredder
will automatically stop
and reverse paper.
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 1 year from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 1 year from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole
and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the warranty are valid worldwide, except where different limitations, restrictions, or conditions may
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other
(Note: two paper detection sensors are
3 4
Clean any contamination
to clean sensors. Make sure
from the paper sensors
brush is clean and dry
3 4
Shred 1 sheet of
If necessary, press
Reverse (R) to run paper to clear
cutters. Resume
shredder in reverse and
then pull uncut paper normal shredding.
from shredder.
Safety Shield
Electronically controlled shield
stops shredder when opened for
advanced safety
OILING SHREDDER
may experience diminished sheet capacity, intrusive noise when shredding and could
each time you empty your waste bin or every 15-30 minutes of continuous use.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
*Apply oil
Set to Off ( )
and unplug across entry
Important: For optimal shredding perfomance, use Fellowes High Security
oil (3525601). *Use of standard shredder oil is not recommended.
us or your dealer.
Auto Shut Off
After 30 minutes of inactivity, shredder
automatically turns off for zero energy
consumption
3
Press Reverse (R)
( ) is blue, resume shredding.
3