Status Indicators; Initial Setup - VT Miltope nMAP Manual Del Usuario

STATUS INDICATORS

Indicator
POWER Indicator Lit green to indicate powered up and enabled for operation. Lit amber to indicate powered up, but operation is disabled
(standby mode). The internal unmanaged Ethernet switch continues to function in standby mode.
RF ENABLE Indicator Lit green to indicate RF output is enabled.* Lit amber to indicated RF output is disabled.
RF ACTIVE Indicator Flashes green to indicate RF data transfers are occurring.
LAN ACTIVE Indicator Flashes green to indicate LAN data transfers are occurring.
Lit solid green to indicate that a link is established on one or both wired LAN ports, but no data transfers are occurring.
* If radio 1 is disabled in the management tool (see software operator's manual), indicator will light amber even though radio 2 is enabled.

INITIAL SETUP

Connect the nMAP Access Point in the lab environment as shown:
ANTENNAS
POWER/DISCRETE TEST CABLE
MILTOPE PART NUMBER 902920-1 (36-INCH),
902920-2 (48-INCH), 902920-3 (72-INCH)
PART NUMBER 902919-1)
115 VAC 28 VDC
OR
(97 - 134 VAC) (18 - 32 VDC)
360 - 800 Hz INPUT POWER
INPUT POWER
nMAP WIRELESS ACCESS POINT
J6 J5 J4 J3 J2
3
2
1
P1
P1
ON
TEST BOX (MILTOPE
OFF
RESET
2
PUSHBUTTON
Function
WHAT IS IN THE BOX: nMAP WIRELESS ACCESS POINT PART NUMBER 902693-1
EQUIPMENT REQUIRED, BUT NOT SUPPLIED:

DESKTOP COMPUTER WITH 10/100 BASE TX ETHERNET CAPABILITY

LAPTOP COMPUTER WITH IEEE 802.11b/g WIRELESS CAPABILITY

THREE ANTENNAS, MILTOPE PART NUMBER 901167-2

TEST BOX, MILTOPE PART NUMBER 902919-1

ETHERNET LAN TEST CABLE, MILTOPE PART NUMBER 902921-1 (36-INCH),
902921-2 (48-INCH), OR 902921-3 (72-INCH)

POWER/DISCRETE TEST CABLE, MILTOPE PART NUMBER 902920-1 (36-INCH),
J1
902920-2 (48-INCH), OR 902920-3 (72-INCH)

POWER SUPPLY, 5 VDC, 0.5 AMP (OPTIONAL)
P2 P1
RJ45-P2
USE OF RJ45-P2 IS OPTIONAL FOR
CONNECTION TO SECOND COMPUTER
ETHERNET LAN TEST CABLE
MILTOPE PART NUMBER 902921-1 (36-INCH),
902921-2 (48-INCH), OR 902921-3 (72-INCH)
RF ON PS ON
5 VDC RETURN
+5 VDC
RF OFF
RF ON
1
1 0
NOTE: The 5-Volt power supply is
used to provide power to
the PS ON and RF ON test
0
box indicators. The 5-Volt
power supply is optional.
3
RJ45-P1
ETHERNET PORT
COMPUTER WITH 10/100BASETX
ETHERNET CAPABILITY
5-VOLT DC, 0.5 AMP POWER SUPPLY
1009162A