Configuration - D-Link DAP-3320 Guia De Instalacion

Connecting to Your Network
You can connect the DAP-3320 to a PoE
switch, or you can use the included PoE
injector to power the AP.
Connecting to a PoE Switch
Connect the Ethernet cable that is
connected to the DAP-3320 to your PoE
switch.
PoE Switch
TECHNICAL SUPPORT
6
D-Link DAP-3320 Quick Install Guide
AP
LAN (PoE)
Computer
Connecting to the PoE Injector
A. Connect the Ethernet cable that is
connected to the DAP-3320 to the
P+DATA OUT port on the PoE injector.
B. Connect an Ethernet cable to the DATA
IN port on the PoE Injector. Connect the
other end of the Ethernet cable to your
network switch or router.
C. Attach the power adapter to the connector
labeled POWER IN on the PoE Injector,
and plug it into an electrical outlet.
D. Purchase separately a DPE-101GI
PoE injector if you need to connect the
Access Point without a PoE Switch.
AP
LAN (PoE)
A
P+DATA OUT
POWER IN
C
Router or Switch Computer

Configuration

If you are configuring the DAP-3320 locally,
connect a PC to same network that the
DAP-3320 is connected to.
A. Assign a static IP address to your PC
that is in the same network segment as
the DAP-3320. As the default IP address
of this unit is 192.168.0.50, you may
choose any address from 192.168.0.1 to
192.168.0.254, except 192.168.0.50.
B. Open a web browser and go to
http://192.168.0.50. Enter admin as your
username and leave the password blank to
log in to the web UI. Now you can configure
the DAP-3320 through the web UI.
dlink.com/support
PoE Injector
DATA IN
B