Technische Angaben / Caracteristicas Tecnicas; Start Up Instructions - Astralpool VIRON P300 Manual De Instalación Y Mantenimiento

TECHNICAL CARACTERISTICS / RENSEIGNEMENTS TECHNIQUES
D
G
F
COD. Cv A
11481 1 II 622

4. START UP INSTRUCTIONS

PRIOR TO START UP
Carry out the following operations before starting the pump:
1. Remove the pre filter cap by unscrewing the nut holding it in place (Fig. 5).
2. Fill the pump with water through the pre filter until it rises up through the suction
3. Should the basket be removed during these operations, do not forget to replace it
4. Check that the mains voltage and power correspond with those indicated on the
Fit the pre filter cap and screw on tight, not forgetting to fit the seal in its housing (Fig.
5).
The pumps must not be run without the pre filter having first been filled with water.
Where this is not the case, the mechanical gasket may be damaged, leading to a loss of
water.
START UP
Open all the valves and connect the motor.
Installation and General Maintenance Manual – Viron P300 Pool Pump
CARACTERISTICAS TECNICAS / DATI TECHNICI

TECHNISCHE ANGABEN / CARACTERISTICAS TECNICAS

E
B C
375 300
pipe.
to prevent large particles from entering the pump that could block it.
pumps characteristics plate.
A
D
B
E F G
346 215 345
H
C
I
H I D
300 120 50
8