Pc Input Terminals Connection - Panasonic TH-37PX25 Manual De Instrucciones

Cable Connection

PC Input Terminals Connection

Conversion adapter
(if necessary)
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200
lines.)
(2) The maximum resolution:
Model
TH-37PX25
TH-42PX25
TH-50PX25
If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
(3) Some PC models cannot be connected to the set.
(4) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(5) The computer shown in the illustration is for example purposes only.
(6) Additional equipment and cables shown are not supplied with this set.
(7) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
Signal Names for D-sub 15P Connector
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
Pin Layout for PC Input
Terminal
18
COMPUTER
Ferrite core (small size)
Connect a cable which matches
the audio output terminal on the computer.
4:3
768 × 720
768 × 768
1,024 × 768
Signal Name
Pin No.
1
2
3
NC (not connected)
4
5 GND (Ground)
Less than
(supplied)
4" (10 cm)
Audio
Stereo plug
Less than
4" (10 cm)
RGB
PC cable
Ferrite core (large size)
(supplied)
Aspect
16:9
1,024 × 720
1,024 × 768
1,366 × 768
Pin No. Signal Name
R
6 GND (Ground)
G
7 GND (Ground)
B
8 GND (Ground)
9 NC (not connected)
10 GND (Ground)
S VIDEO VIDEO L AUDIO R
INPUT 3
Less than
4" (10 cm)
D-sub 15p
Pin No. Signal Name
11 NC (not connected)
12 NC
13 HD/SYNC
14 VD
15 NC
PC