Outdoor Sensor Positioning - La Crosse Technology 512-811-BBB Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setup with Multiple Sensors
The clock can receive up to 3 outdoor sensors: W186-D.
Select a separate channel on each outdoor sensor.
Install batteries in all the sensors.
Hold the CH button for 5 seconds and the clock will
search for all outdoor sensors.
Press the TX button once on each sensor to send a
signal.
Search for Outdoor Sensor
Hold the CH button to search for the outdoor sensor.
Press the TX button on the sensor to send a signal.
Restart
If there is no outdoor temperature data after 3 minutes,
remove batteries from the clock and the outdoor sensor then
press any button 20 times. After 15 minutes, return to Step 1
above.

Outdoor Sensor Positioning

Mount the outdoor sensor on a north-facing wall or in any
well shaded area. Under an eave or deck rail is preferred.
The maximum wireless transmission range to the clock is
over 100 feet (30 meters) in open air, not including walls or
floors.
Be sure the outdoor sensor is mounted vertically
Care & Maintenance
Do not mix old and new batteries
Do not mix Alkaline, Standard, Lithium or Rechargeable
Batteries
Always purchase the correct size and grade of battery most
suitable for intended use.
Replace all batteries of a set at the same time.
Clean the battery contacts and also those of the device prior
to battery installation.
Ensure the batteries are installed with correct polarity
(+and -).
Model: 512-811-BBB
www.lacrossetechnology.com/support
| 5

Publicidad

Tabla de contenido
loading

Tabla de contenido