Electrical Connection; Control Panel Installation - Palazzetti ECOFIRE DA INSERIMENTO Manual De Instalación, Uso Y Mantenimiento

6.7 CREATION OF UTILITY HOLES ON
CLADDING
&ODGGLQJ LV WR EH PDGH RQO\ E\ TXDOL¿HG SHUVRQQHO
Utility holes must be made in the cladding for the
following:
A) display slot;
B) ventilation vents;
C) heat release in hood;
D) ventilation of cladding on base;
E) intake vents on base motor;
F) loading of pellets onto hood;
The holes must comply with the measurements
shown in Fig. 6.6.1.
6.8 CONNECTION TO SYSTEMS

6.8.1 Electrical connection

Simply connect the stove to the electricity mains
with the plug supplied.
)
7KH HOHFWULFDO FRQQHFWLRQ SOXJ PXVW EH HDV\ WR
access also after the stove has been installed.
If the power lead is damaged it must be replaced
E\ WKH WHFKQLFDO DVVLVWDQFH VHUYLFH RU D TXDOL¿HG
electrician to prevent all risks.
6.8.1.1 Earthing
DANGER
7KH V\VWHP PXVW EH HDUWKHG DQG ¿WWHG ZLWK D FLUFXLW
EUHDNHU DV SURYLGHG IRU E\ FXUUHQW ODZV )LJ  
7KH ÀXH PXVW KDYH LWV RZQ HDUWK FRQQHFWLRQ

6.8.2 Control panel installation

7KH ¿UHSODFH¶V FRQWURO SDQHO FDQ EH ZDOO PRXQWHG
using box "A" or recessed using box "B" (not
included).
DANGER
Do not install the recessed box on the hood.
)
Place the passage of the cable between the panel
and the electronic card so that it is not damaged by
WKH WHPSHUDWXUH RI WKH ¿UHSODFH DW QRUPDO RSHUDWLQJ
temperature.
Connect the cable between the terminals of the
electronic card and the control panel before closing
the boxes.
6.8.3 Connection to room thermostat
The stove is set up for connection to an external
room thermostat (in normally open position).
Where available, on the upright of the stove there
is the connector for the insertion of the cables C
of the room thermostat , terminals 1 and 2 as per
image (Fig.6.7.3).
52/164
INSTALLATION
E
1
cod. 00 477 1480 - 12/2012 - Palazzetti - PN - Italy
C
B
F
2 9
5
5
2 9
B
F
A
D
4
3
2
1
4
3
Fig. 6.6.1
Fig. 6.7.1
2
Fig. 6.7.2