Paslode T200-F18P Manual De Instrucciones página 5

INSTRUCTIONS FOR LOADING
Step No. 1 – Disconnect the tool from its air source.Grasp the finish nailer firmly with one hand and press the
orange magazine release button at the
rear of the handle and slide the magazine cover back towards you.
Disconnect air
Press release.
Slide cover
Step No. 2 – Insert the strip of 18 gauge brad nails with the point of the fastener facing down and place the point
of the fastener into the bottom of the magazine channel. Placing fasteners on the top of the magazine will cause
jamming.
Step No. 3 – Push the magazine firmly towards the front of the tool until it locks in place. Connect the air supply.
The tool is now ready to use. .
5