Tabla de contenido
Publicidad
MAINTENANCE
A
C
I T
O
N
Add several drops of pneumatic
oil into the air fitting.
Check that all screws on tool
are tight.
Keep work contacting elelment
working properly.
Keep magazine and feeder
mechanism clean.
Lubricate "O" rings that are
replaced.
Use only Paslode replacement
parts.
OPERATOR TROUBLESHOOTING
PROBLEM
Fasteners will not drive completely into wood.
Fasteners drive too deeply into wood.
Fastener jams in nose of tool.
Tool skips during operation - no fasteners are driven
from time to time.
W
H
Y
Keep tool lubricated.
Prevent air leakage and pro-
mote efficient operation.
Promote operator safety and
efficient tool operation.
Prevent jamming of fasteners.
Assure long life and proper
operation of tool.
Keep tool operating efficiently
and maintain Paslode tool
warranty.
Adjust the
Increase air pressure (do not exceed 120 psi).
Adjust the
Reduce air pressure.
Open front guide latch, release jammed fastener,
and close latch securely.
Check magazine for proper fasteners. Magazine
follower should slide freely. Clean as needed to
remove debris.
Make sure correct fasteners are being used.
Use fasteners that meet Paslode
9
Use Paslode pneumatic
tool lubricant. Part No.
403720.
Check screws daily.
Inspect and blow clean daily
and check for proper operation.
Blow clean daily.
Use Chemplex grease, Part
No. 403734.
Order any replacement parts
needed from Paslode Dealer.
CAUTION
Disconnect the tool when performing
repairs or clearing jams.
CORRECTIVE ACTION
depth of drive adjustment
depth of drive adjustment
H
O
W
(retract length).
(extend length).
®
specifications only.
Publicidad
Tabla de contenido
