Troubleshooting - Porter Cable PCC842L Manual De Instrucciones

Destornillador 8v max

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

screw driving

For driving fasteners, the foward/reverse button should be pushed to the left. Use reverse

(button pushed to the right) for removing fasteners. When moving from forward to reverse,

or vice versa, always release the trigger switch first. Release trigger when the fastener is at

the desired depth.

note: For best performance, use 2" fasteners or smaller, or screw into pre-drilled holes.

note: The impact mechanism of the screwdriver creates a loud, impacting noise when

extra force is needed. This noise is normal; the screwdriver is not malfunctioning or broken.

iMpact driver warnings:

• Hold the tool as shown in figure d.

• Do not use tool as a pry bar.

• To avoid being turned on accidentally, do not carry in your

pocket.

on Board Bit storage (figure e)

Two magnetic bit holders (4) are built into the area on top of

the screwdriver for easy storage and access.

drilling

• Use sharp drill bits only.

• Screwdriver is ideal for bits 1/4" or smaller.

• Support and secure work properly, as instructed in the

Safety Instructions.

• Use appropriate and required safety equipment, as

instructed in the Safety Instructions.

• Secure and maintain work area, as instructed in the Safety

Instructions.

• Apply pressure in a straight line with the bit. Use enough

pressure to keep the bit biting but not so much as to stall

the motor or deflect the bit.

• DO NOT CLICK THE TRIGGER OF A STALLED

SCREWDRIVER OFF AND ON IN AN ATTEMPT TO

START IT. DAMAGE TO THE SCREWDRIVER CAN RESULT.

• Minimize stalling on breakthrough by reducing pressure and slowly drilling through the

last part of the hole.

• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce

jamming.

• Make sure switch turns screwdriver on and off.

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the

tool; never immerse any part of the tool into a liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and

adjustment (other than those listed in this manual) should be performed by authorized

service centers or other qualified service personnel, always using identical replacement parts.

problem

• Unit will not start.

• Battery pack will not charge. • Charger not plugged in.

For assistance with your product, visit our website at www.portercable.com for a

list of service centers, or call the PORTER-CABLE Customer Care Center at

(888) 848-5175.

Maintenance