Menu Settings Table - Oki Microline 320 Turbo Actualización Del Producto

English

Menu Settings Table

The settings listed below are the changes or additions to those listed in the User's Guide.
For a complete explanation of the menu and each menu item, refer to the User's Guide, "Using Your Printer, Menu
Mode, Explanations of Menu Items."
The User's Guide is provided as an Adobe Acrobat file on the CD provided with your printer.
The table below shows the items that may appear in the menu. Settings which are engaged at the factory (defaults)
are set in bold italic. Some groups or entries will only appear when a specific emulation is engaged, as noted.
Group
Symbol Sets
(ML390/391 Series
printers only)
Top Feed
Set-Up
Serial I/F
CSF Bin 1
CSF Bin 2
Item
Code Page
Form Tear-off
CSF Bin Select
CSF Type
ESC SI Pitch
Serial I/F only appears when an optional Serial Interface board is installed.
Parity
Serial Data 7/8 Bits
Protocol
Diagnostic Test
BusyLine
Baud Rate
DSR Signal
DTR Signal
Busy Time
CSF Bin 1 only appears when an optional Cut Sheet Feeder is installed.
Line Spacing
Bottom Margin
Page Width
Page Length
CSF Bin 2 only appears when an optional Dual Bin Cut Sheet Feeder is installed.
Line Spacing
Bottom Margin
Page Length
(Defaults are set in bold italic)
USA, Canada French, Multilingual, Portugal, Norway,
BRASCII, Abicomp, Multilingual 858, ISO 8858-15
Form Tear-off only appears when an optional Roll Paper
Stand is installed.
OFF, 500 ms, 1 sec, 2 sec
CSF Bin Select only appears when an optional Dual Bin Cut
Sheet Feeder is installed.
Bin 1, Bin 2
CSF Type only appears when an optional Cut Sheet Feeder is
installed.
Wide, Narrow
17.1 CPI, 20 CPI
None, Odd, Even
8 Bits, 7 Bits
Ready|Busy, X-ON/X-OFF
No, Yes
SSD -, SSD +, DTR, R TS
9600, 4800, 2400, 1200, 600, 300, 38400, or 19200 BPS
38400 BPS is displayed only when an optional serial
interface board with 38400 firmware is installed.
Valid, Invalid
Ready on Power Up, Ready on Select
200 ms, 1 sec
6 LPI, 8 LPI
Valid, Invalid
13.6", 8"
The setting for Page Width affects both Bin 1 and Bin 2.
On a wide-carriage printer (321, 391), when Page Width is
set to 8", the printer prints 8" wide lines, not the full width
of the printer.
11", 11 2/3", 12", 14", 17", 3.5", 4", 5.5", 6", 7", 8", 8.5"
6 LPI, 8 LPI
Valid, Invalid
11", 11 2/3", 12", 14", 17", 3.5", 4", 5.5", 6", 7", 8", 8.5"
3 - English
Settings