Troubleshooting; Before Calling For Service - LG LDF8574ST Manual Del Propietário

BEFORE CALLING FOR SERVICE

Problem
Door is not completely closed.
Dishwasher will not
Power supply or power cord is not connected. Connect the power supply or cord properly.
operate
Fuse is blown or circuit breaker tripped.
Dishwasher operates too
Dishwasher is connected to cold water.
long
Previous cycle was stopped before
Odor
completion.
Water remains in tub
Drain hose is kinked or clogged.
after completion of cycle
Low water temperature.
Spots and filming on dishes
Wrong amount of detergent used.
Overloading.
Improper loading.
Insufficient water pressure.
Insufficient detergent.
Rinse aid dispenser is empty.
Extremely hard water
The best way to eliminate spots on your dishes is to install a whole house water softener in your home. If a
water softener is already installed or you do not plan on installing one, try adding the "Extra Rinse" option
as part of the wash cycle to help minimize this condition. To add an extra rinse to the cycle, select the wash
cycle and then press the RINSE button.
NOTE: Selecting "Extra Rinse" will increase cycle times and water usage.
To remove hard water build up in the tub
Remove all dishes, silverware and the silverware holder from the dishwasher. Only the racks should remain
in the tub.
Fill a measuring cup with white vinegar, approximately 14~17 ounces (400~500mL), and place the measur-
ing cup in the lower rack.
Run a Normal cycle and select Extra Rinse
DO NOT USE DETERGENT
NOTE: Make sure to let the dishwasher complete the entire cycle. This cleaning method should only be
done as needed.
If you have followed this troubleshooting guide and the problem persists, or if the problem you are experiencing is not listed here, please
call LGE Customer Service at 1-800-243-0000(US), 1-888-542-2623(Canada).
Possible Causes

TROUBLESHOOTING

Solutions
Make sure that the door is completely closed and latched.
Replace the fuse or reset the circuit breaker.
Check the water supply connection or water heater set-
ting. (Heating cold water takes longer.)
Operate the Quick cycle with detergent without loading
any dishes.
Adjust hose or clear blockage.
Water supply should be at least 120°F for best wash per-
formance.
Use the recommended amount of detergent.
Do not overload the dishwasher.
See the Using Your Dishwasher section.
Water pressure should be between 20 and 120 psi.
Add the recommended amount of detergent. See the Us-
ing Your Dishwasher section.
Refill rinse aid dispenser.
and Sanitary then close the door.
27