EGO PH1400E Manual Del Operador página 14

TROUBLESHOOTING
EN
PROBLEM CAUSE
◾
The battery pack is not
attached to the pole saw.
◾
No electrical contact between
the saw and battery.
◾
The battery pack is depleted.
◾
The lock-off button is not
depressed before pressing the
trigger.
Motor does not
◾
run.
The battery pack or power
head is too hot.
◾
Saw chain is bound in the
wood.
◾
Debris in bar groove.
◾
Debris in chain-sprocket cover.
◾
Chain does not engage drive
Motor runs, but
sprocket.
chain does not
rotate.
◾
Insufficient chain tension.
◾
Dull chain.
◾
Chain installed backwards.
Pole saw does
◾
Worn chain.
not cut properly.
◾
Dry or excessively stretched
chain.
◾
Chain not in bar groove.
◾
Check chain tension for over
tightened condition.
Bar and chain
running hot and
◾
Chain oil tank is empty.
smoking.
◾
Debris in guide bar groove.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
14
POLE SAW ATTACHMENT — PSA1000
SOLUTION
◾
Attach the battery pack to the pole saw.
◾
Remove battery, check contacts and reinstall the battery pack.
◾
Charge the battery pack.
◾
Press down the lock-off lever and hold it, then depress the
trigger to turn on the pole saw.
◾
Allow the battery pack or power head to cool until the
temperature drops below 152°F (67°C).
◾
Release the trigger; remove the saw chain and guide bar from the
wood, then restart the pole saw.
◾
Press the saw chain against the wood, move the pole saw back
and forth to discharge the debris.
◾
Remove battery pack, then remove chain-sprocket cover and
clean out debris.
◾
Remove the battery pack and reinstall the chain, making
sure that the drive links on the chain are fully seated on the
sprocket.
◾
Remove the battery pack and readjust the chain tension,
following the section "ADJUSTING THE CHAIN TENSION".
◾
Sharpen the chain cutters by a qualified service technician.
◾
Remove the battery pack and reinstall the saw chain, following
the section "REPLACING THE BAR AND CHAIN".
◾
Remove the battery pack and replace the chain following the
section "REPLACING THE BAR AND CHAIN".
◾
Check the oil level. Refill the oil tank if necessary.
◾
Remove the battery pack and reinstall the saw chain, following
the section "REPLACING THE BAR AND CHAIN".
◾
Remove the battery pack and re-tension the saw chain; see the
section "ADJUSTING THE CHAIN TENSION".
◾
Filling bar and chain lubricant.
◾
Clear the debris in the groove.