Dual-Carriage Setup
The Curio provides a dual-carriage to hold two different tools
simultaneously. This allows you to perform a variety of actions during
the same job. The two carriages are labeled as red (or Tool 1 on the
left side) and blue (or Tool 2 on the right side). Tools can be used
interchangeably in either carriage.
To load a tool into the desired carriage, unlock the tool holder by
turning the lock lever counter-clockwise.
Place the tool in the tool holder and
turn the lock lever clockwise to secure
the tool. Be sure the tool is pressed
completely into the holder.
Sending Your Job to the Curio
Click the Cut Settings button on the toolbar at the top of the screen. The Cut Settings
panel will appear on the right side of the screen.
loosen
fasten
lock lever
Cut Order
Select
Media Type
Send to Silhouette
Getting Started with Silhouette Curio™
tool holder 1
tool holder2
tool
10