Nederman 865 Serie Manual De Usuario página 11

After installation check that the functions for uncoiling and coiling the hose correspond to the
press button arrows on the hand control. If not, reconnect the cable from the hand control
correctly on the connection block.
Cable recommendation for the hand control:
3 x 0,75 mm2, to be connected according to the wiring diagram.
The reel is factory set for a voltage supply of 230/240 V AC
4.5 Setting the code
Only for remote controlled hose reel.
To allow the use of a number of reels in one location, the reel must be coded. NB! Each reel
must have its own code. At delivery code C has been set (see figure). To set another code:
1. Make sure the reel is connected to the power supply.
2. Open the hand control and set one of 8 possible codes.
3. Put the hand control together. Then aim it against the reel's indicator and push the SET-
button (minimum 7 s) The indicator verifies by green flashing light for approximately 2 s.
Using the enclosed labels (A B C), mark the hand control and the reel with the same code
letter.
If more than 8 reels are to be used in the same room, reels with the same code should be placed
at least 10 m from each other to reduce the risk of interference.
4.6 Adjusting the limit positions for coiled and uncoiled hose.
When delivered the reel has the limit positions adjusted for the hose mounted on the reel.
When needed the limit positions can be adjusted again. A reset of the limit positions then must
be done in the following way. Push the up- and down-buttons on the hand control at the same
time (10 s) until the indicator has fixed red light (2 s.)
NOTE! Both limit positions must be
Adjusting the upper limit position
1.
Push the up-button on the hand control. Let the hose be moved to required upper
position. Release the button.
2.
Push the up- and down-button at the same time. The indicator is flashing green (8x) for a
short time. The limit position has now been adjusted.
Adjusting the lower limit position
1.
Push the down-button on the hand control. Let the hose be moved to required lower
position. Release the button.
2.
Push the up- and down-button at the same time. The indicator is flashing green (5x) for a
short time. The limit position has now been adjusted.
5 Applications
Nederman Exhaust Reel is designed for stationary use only and can, depending on hose
diameter, be connected to cars, trucks or other vehicles with similar motor sizes. The following
air flows are recommended:
Reels for cars
75/100 mm (3"/4") hose: 400 - 600 m3/h (235 - 350 cfm)
adjusted, always the upper at first, then the lower.
Exhaust Hose Reel EN
11