Publicidad
Idiomas disponibles
Idiomas disponibles
2 - DISASSEMBLING ELECTRICAL PARTS
ATTENTION! Before working on electrical parts be
sure the appliance has been disconnected from
the mains.
In order to replace the fans, observe the following
instructions:
1. Remove the four screws holding the front
of the fan support tray (Fig.1). In the case of
Nature 70/80 models, there are two screws
instead of four.
FIG. 1 - Nature 100
2. Once the 4 screws have been loosened (two
in the Nature 70/80 model) remove the fan
support tray (Fig. 2). Be especially careful when
removing the tray so as not to cut or damage
the wiring.
FAN
SUPPORT TRAY
FIG. 2 - Nature 100
3. Once the fan support tray has been removed,
you can access the servo housing (Fig. 3-4).
SERVO HOUSING
SERVO
REPLACING THE POWER SUPPLY CABLE
If the power supply cable has been damaged, it
should be replaced by the manufacturer, via its
Technical Service, or by qualified personnel, in
order to avoid risks.
INDUSTRIAS HERGÓM, S.A., rejects any liability
derived from a faulty installation or incorrect use
and reserves the right to alter its products without
prior warning.
Any liability due to manufacturing defects will
be subject to the criteria and verification of the
company's experts and will be limited to the
repair or replacement of its products, excluding
any construction work or damage the said repairs
may cause.
FAN HOUSING
FIG. 3-4
Publicidad
