Important - Craftsman CMXGMAM1125501 Manual De Instructiones

5. Remove T-bolts from the handle brackets as shown in Figure 6.
6. Follow the steps below to complete handle assembly:
a. Pull upward on the handle until holes in lower handle (shown in
Figure 6 deck cutaway) line up with holes in handle bracket.
See Figure 7.
NOTE: When pulling upward on handle, make sure to not pull handle all the
way out.
b. Insert the T-bolts removed in Step 2 through the handle brackets and
lower handle and tighten securely to secure the handle in place. See
Figure 7.
a
b
7. The rope guide is attached to the right side of the upper handle. Loosen the
wing knob which secures the rope guide. Refer to Figure 8.
a. Hold blade control against upper handle.
b. Slowly pull starter rope handle from engine and slip starter rope into
the rope guide. See Figure 8.
c. Tighten rope guide wing knob.
d. Use cable ties provided to secure blade control and drive cables to
lower handle as shown in Figure 8.
Figure 6
b
Figure 7
ASSEMBLY
IMPORTANT: To reduce wear and allow for proper operation, make sure to
leave some slack in the upper portion of the cable(s).
a
b
Attaching the Grass Catcher
1. Follow steps below to assemble the grass catcher. Make certain bag is turned
right side out before assembling (warning label will be on the outside).
a. Place bag over frame so that its black plastic side is at the bottom.
b. Slip plastic channel of grass bag over hooks on the frame. See Figure 9.
b
2. Follow steps below to attach grass catcher:
a. Lift rear discharge door.
b. Place grass catcher into the slots in the handle brackets as shown
in Figure 10. Let go of discharge door so that it rests on the grass
catcher.
To remove grass catcher, lift rear discharge door on the mower. Lift grass catcher up
and off the slots in the handle brackets. Release rear discharge door to allow it to
close rear opening of mower.
8
c
Figure 8
Figure 9
d
a