Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Health airflow up/down function (Only valid for part of models)
(1) The function can be set through wired controller or remote controller.
(2) The function circulation is as follows:
(Only when Left/Right swing is valid) →
(Only when Up/Down swing is valid)→ →
(ventilation function)→
(reserved function)→
→
(When it's time for filter cleaning, this
icon will involve in circulation) →
(the second 8 of 88.8 in the temp. display area displaying A,only
valid for part of models)→
(the second 8 of 88.8 in the temp. display area displaying B,only valid
for part of models)→
(motion sensing,only valid for part of models) →10°C heating function(this
function only works in the heating mode, only valid for part of models) → health airflow up (Only valid
for part of models) → health airflow down (Only valid for part of models)
(3) The function is valid only when the angle of Up/Down swing can be set.
(4) Health airflow up/down function cannot be set at the same time. When the latter is set, the former
will be automatically canceled.
(5) After the function is set, the angle of Up/Down or Left/Right swing can be normally adjusted in the
main interface. Press the SET key to enter function circulation. When Up/Down swing icon flashes,
press SET key, and then swing angle position 1 will flash. Press Up/Down key to adjust the angle.
When the adjusted swing angle is executed, the health airflow up/down is canceled simultaneously.
Sleeping
(1) Press
key to enter function setting, press
to the sleeping icon " " and it will flash,
the sleeping time will display by the
which is on the top-right corner. Press Time key to enter
sleeping time setting. "OFF" and sleeping icon are flashing. Press
to adjust the sleeping time by
0.5h once, the range of sleeping time is from 0.5h to 72h. After the adjustment, press
key again to
confirm the operation. "OFF" and sleeping icons are statically displayed.
(2) During sleeping icon is flashing, pressing
key instead of
key, the wired controller will
take the converse operation of previous sleeping state. If there is sleeping set, cancel it; if not, come
into the setting operation.
(3) If power off is executed during sleeping, the sleeping function is cancelled at the same time; there
is no display when powered on again. It needs to be reset if any requirement.
13
Publicidad
